TRIMZILLA 16" Bowl Leaf Trimmer

TRIMZILLA 16" Bowl Leaf Trimmer

  • £160.00


Save Time and Money with a Trimzilla Bowl Trimmer

The Trimzilla 16" Bowl Trimmer is an extremely cost-effective way to get your crop trimmed in next to no time. It's simple and effective, with no mechanical parts - just wack your produce in the top chamber, turn the handle and you'll be left with a great looking end-product.

  • One of the simplest and most cost-effective ways to automate the trimming process
  • A real bargain - represents exceptional value for money
  • Hand-driven - uses no electrical parts
  • Lightweight and portable - easy to travel around with
  • Clear plastic lid, allowing you to guage when your produce is ready
  • Saves hours of time compared to hand trimming with scissors
  • Features removable rubber tongues, allowing them to be easily cleaned
  • Comes with two sets of spare 4-way wire blades
  • Collects leaf matter and waste, keeping everything tidy

Contains

Trimming bowl, 2 x sets of 4-way wire blades, 1 x clear plastic lid with high-density rubber tongues, 1 x grill with gearbox and 2-way blade, 1 x handle with Allen key, washer and screw

How the Trimzilla 16" Bowl Trimmer Works

Trimming the traditional way (hunched over your plants with scissors) is arduous and time consuming. The Trimzilla makes life easy by automating the process. It's comprised of three main parts: a lid (with a handle and a series of removable rubber tongues), a grill (with a gearbox and a set of blades), and a bowl for collecting the waste. The Trimzilla is fitted with a sharp two-way blade as standard and comes supplied with two spare sets of four-way trimming wires.

The basic concept is very simple: turn the handle and it will rotate the rubber tongues, which push plant material around the top chamber. At the same time, the blade that sits underneath the grill spins. As the plant materials move around the chamber, any leaf matter that's find it's way through the grill gets chopped off. The Trimzilla uses a gearbox (which is attached to the grill) to keep the blade and the tongues rotating at different rates. The tongue moves materials around the chamber slowly while the blade spins faster than the eye can see.

Leaves that are trimmed from your produce are collected in the bowl, keeping everything nice and tidy. You can then put these materials to good use in other areas if needs be.

The Trimzilla Bowl Trimmer is great for hobbyist growers. 

Dimensions

Diameter: 41cm (16")

Height (including handle): 41cm (16")

How to Use the Trimzilla

Fit the handle to the lid using the screw, washer and supplied allen key. Place the bowl on a table or flat surface and fit the grill on the top, so that the blade faces downwards.

Place no more than 40 grams of untrimmed plant materials onto the grill. Put the lid on, ensuring that the spindle sits inside the gearbox. Turn the handle clockwise to start the trimming process, at the rate of about one turn every 2 to 3 seconds. Official instructions are 15-30 turns, but we recommend starting off at around six and working your way up. Optimal procedures will depend on the density and conistency of the material, so it makes sense to start off lower and work your way up until you get a feel for it.

Once your plant material has been trimmed thoroughly, take the top off and remove it. Place the next batch in if necessary. Every few batches, check under the grill and empty the trim out of the bottom bowl if necessary. Make sure that the SpinPro is cleaned well after use to maintain its effectiveness and lifespan. This is very important